Repair Restoration Airbag. Correction of the odometer and mileage speedometer

Restoring the performance of SRS Airbag control units. With departure. To remove manufacturers after an accident, the SRS AIRBAG unit must be replaced with a new one, so the record of the accident blocks its further operation even if the system itself is not damaged and can function flawlessly. Removing "crash-data" at the program level is quite difficult, not every specialist is able to cope with such a task. But this does not mean that the accident record cannot be deleted. Our craftsmen know how to do this and quickly restore airbags to a clean, pre-crash memory. All modern cars are equipped with AIRBAG and SRS airbags. The airbag system of most vehicles consists of the following components: 1. airbag control unit (central airbag system control unit or SRS) 2. Impact sensors (front, side) 3. Passenger presence sensor (mat in the passenger seat) 4. Driver's seat position sensor ( optical sensor in the driver's seat skid) 5. Airbags (front, in the seats, ceiling curtains, leg airbag, etc.) 6. Seat belt igniters (in the rack, combined with the belt latch, in the floor) 7. Belt latches safety (we fasten the belt to them) 8. Passenger AIRBAG switch (for child seat) Failure of any of the listed components of the airbag system entails an error, as evidenced by a warning light on the instrument panel in the form of a symbol or the inscription airbag or SRS . If the airbag system is fully functional, the warning light comes on when the ignition is switched on and goes out after a few seconds. The fact that the airbag lamp does not go out after the ignition is switched on means that the airbag system is not activated and the airbags will not deploy in the event of an accident. In this case, AIRBAG SRS diagnostics and repair is required