Transparent epoxy resins. Fill 1-3.3-6 cm. Made in Russia

TRANSPARENT colorless epoxy resin (complete with hardener) grades EPILITE-T and EPILITE-L Designed for the manufacture of epoxy products by layer-by-layer pouring in thin layers (2-15 mm). It is a "fast" fast system, it can be used for priming dried wood, strengthening its surface. Advantages of the Epilight-T composition over well-known brands of epoxy resins: - easy pouring, low viscosity, - high curing speed, - possibility of polishing after curing. Epilight-T is supplied as a set in the form of resin (component A) and hardener (component B), mixed before pouring in a ratio of 100:50 by weight until a homogeneous state. Mixing of the components must be carried out in clean dishes and clean tools without residues of old resins, carefully, along the walls and bottom of the container. Filling is recommended to be carried out at 22-25 ° C in a thin stream. To remove bubbles, use a hair dryer, burner, corrector sprays, defoamers such as BYK A530 (0.025-0.030% by weight of component A). When working with a hair dryer or torch, do not overheat the resin, so as not to cause accelerated, uneven curing. The tree is pre-dried and primed, for example, with the same composition of Epilight-T. Small bubbles in the unevenness of the wood, in the corners of the fill must be pushed into the middle of the fill. In the case of complex and/or thick pours, curing can be carried out at a lower temperature - 18°C to reduce the risk of cracking. For multi-layer pouring, apply the next layer on a slightly set (to hard rubber) bottom layer. Curing takes place at 22-25°C, at a relative air humidity not higher than 60% (preferably up to 50%) in a 2 mm layer during the day, with the initial hardening of about 12 hours, followed by strength and hardness for 6-8 days. There may be some deviations from this pattern, with a large thickness, the curing rate increases significantly. We recommend polishing no earlier than after 3 days, since a set of hardness is needed. Designed for the manufacture of slab tables and other work with pouring large thicknesses at a time - 3-6 cm, and in the case of an experienced consumer - greater thickness. Advantages of the Epilight-L composition over well-known brands of epoxy resins: - calm and uniform curing in a thick layer without pronounced exotherm (heat release) - resistance to yellowing, - impact strength. Epilight-L is supplied as a kit in the form of resin (component A) and hardener (component B), mixed before pouring in a ratio of 100:30 by weight until a homogeneous state. Mixing of the components must be carried out in clean dishes and clean tools without residues of old resins, carefully, along the walls and bottom of the container. Filling is recommended to be carried out at 22-25 ° C in a thin stream after a short settling of the mixture. The removal of bubbles occurs mainly by itself, if necessary, you can use a hair dryer, burner, spray-correctors, defoamers such as BYK A530 (0.025% by weight of component A). When working with a hairdryer or a burner, do not overheat