Bitumen, bituminous mastic and bituminous primer

I will sell wholesale and retail Construction bitumen, bituminous mastic and bituminous primer in any quantity at the lowest prices. All goods are new, fresh, direct deliveries from the factory. The warehouse is located at pr. 312 rifle division 20. Bituminous primer Scope: Priming of concrete and metal surfaces to ensure the best adhesion of welded roofing and waterproofing materials, flexible tiles, as well as to improve adhesion to the treated surface of coating waterproofing mastics. Description of material: Bituminous primer - composition based on high quality petroleum bitumen, organic solvent and plasticizer. Features: Bituminous primer is compatible with most bituminous and bitumen-polymer materials, has a short drying time, high penetrating power, effectively impregnates and binds dusty dirt. Does not contain toluene or other toxic solvents. Characteristics: Drying time of one layer at 20? C, h, no more than - 24 Mass fraction of non-volatile substances,%, no less than - 45 Softening temperature of the dry residue,? C, no less than - plus 85 Spreading power (consumption) - 0.14 l / m. kv depending on the surface structure and the number of applied layers. Production of work: Before use, mix the bituminous primer thoroughly throughout the entire volume. If necessary, dilution with white spirit, solvent or solvent gasoline is possible (do not use motor gasoline, as its vapors can be poisonous). When working in conditions of negative temperatures, it is recommended to warm the bituminous primer in greenhouses during the day at a temperature of at least 15 ° C. The surface to be treated must be dry, previously cleaned of dirt, fragile remnants of the old coating, snow and ice. Wet surfaces are recommended to dry with gas burners. Clean rusty metal surfaces mechanically and treat with a rust converter. The bituminous primer is applied by brush, paint roller, mop or by spraying. The bituminous primer can be used at an ambient temperature of at least minus 5°C and no precipitation. Attention! It is forbidden to start laying the deposited materials until the applied layer is completely dry. AquaMast waterproofing bituminous mastic for foundations is a completely ready-to-use material based on petroleum bitumen, containing technological additives, mineral fillers and a solvent. Scope: It is intended for coating waterproofing of structures (concrete, reinforced concrete, metal, wood, etc.) buried in the ground and in contact with a humid environment: foundations, piles, etc. Mastic consumption per 1 layer is 1 kg/m2. When applied to a vertical surface - 0.7 kg/m2.