Sanitizing solution against microorganisms. SanierLosung 0,5l.

Sanitizing solution against microorganisms. Does not contain solvents. For interior and exterior use. Technical description Product type Ready-to-use, aqueous solution for the treatment of facades and walls damaged by fungus, mold and algae. Ingredients Water, styrene-acrylic dispersion, algicidal (destroying algae) and fungicidal (destroying fungi and mold) additives, preservative. Color White, colorless when dry. Density Approximately 1.0067 g/cm3. Application By brush, roller, airless spray (nozzle 0.021 to 0.026 inch or 0.523 to 0.66 mm, pressure 8-10 atm, spray angle 40-80°). Application Ready-to-use, aqueous solution for the treatment of facades and walls damaged by fungus, mold and algae (baths, showers, kitchens, cellars, etc.). Sanitizing solution can be used both for internal and external works (concrete, plaster, putty, brick, etc.). Properties An aqueous solution with an effective spectrum of action against microorganisms such as fungi, mold and algae. In addition to killing and preventing the growth of microorganisms, the solution strongly bleaches the algae at the same time. Do not dilute with water! Substrate preparation Substrates must be solid and dry. Remove loose coatings carefully. Damaged surfaces are cleaned of mold stains with a damp cloth or wire brush. Application procedure On the prepared, cleaned substrates, apply the sanitizing solution with a brush or roller over the entire surface. After 1-2 hours (depending on the damage) the entire surface is treated a second time until saturation. Then let it dry for 24 hours. Then you can proceed to further finishing work. Drying time At approx + 20?C 24 hours after applying the 2nd layer. At lower temperatures, the drying time increases accordingly. Compatibility Can be mixed with all dispersion paints and synthetic based coatings. General instructions During the processing and drying process, the temperature of the air, the material and the substrate must be above +5°C. In order to guarantee a good effect of the material, the sanitizing solution Sanier Lösung should not be mixed with other sanitizing agents. Material consumption 50-100 g/m2 with moderate absorbency of the base and two-layer application. For the most accurate calculation of consumption in each case, it is recommended to carry out a test priming on the site. Cleaning of tools Rinse working tools immediately after work with water, adding detergents used in the household. Storage Store in a cool and dry place protected from frost. Seal the opened package tightly. Shelf life in the original packaging of the manufacturer is 12 months. Freezing is not subject. Packing 0.5 l, 1 l, 5 l Precautions Keep out of the reach of children. Do not inhale vapors when spraying. Ventilate the room well during and after handling the product. In case of contact with eyes or skin, cf.